Next
ReferenceHardwareICDsRename and delete

Rename and delete ICDs

Rename ICDs, messages, and fields, or delete them.

Rename an ICD to give it a clearer name. Delete an ICD that no task uses any more.

Rename ICDs

Right-click the ICD in the ICDs toolbar and select Rename. You can also click the name at the top of the ICD’s tab.

Tasks refer to an ICD by key. They continue to work after a rename, and they do not need a redeploy.

Rename messages and fields

Open the ICD, select the message, and change its Name. To rename a field, change the Name in its line of the fields table. Tasks refer to messages and fields by key, so they continue to read them.

A new field name applies only to channels that a later deploy creates. A channel that the field already writes keeps its name. A running task that reads the message shows Redeploy.

Delete ICDs

You cannot undo a delete.

Select one or more ICDs in the ICDs toolbar. Right-click the selection, select Delete, and confirm.

You cannot delete an ICD that a task uses. Synnax refuses the delete, and the error names the task. Remove the entries that use the ICD from the task, or delete the task, then delete the ICD.

Remove messages and fields

Open the ICD. To remove messages, select them, right-click, and select Remove. To remove a field, click at the end of its line in the fields table.

A task that reads a removed message shows “Message not found” in place of the message, and it does not deploy. Remove that message from the task to deploy it again.

When you open a task, the Console drops the binding of each removed field. After you deploy the task again, the channel of that field gets no new data. A task that code configures with a binding of a removed field does not deploy, and the error says that the field does not exist in the message.